The fabric is the back-to-back data connection between the nodes in a cluster. Traffic on one node that needs to be processed on the other node or to exit through an interface on the other node passes over the fabric. Session state information also passes over the fabric.
Before You Begin |
|---|
Read: |
In most SRX Series devices in a chassis cluster, you can configure any pair of Gigabit Ethernet interfaces or any pair of 10-Gigabit interfaces to serve as the fabric between nodes. For SRX210 devices, both interfaces must be of a similar type (that is, a pair of Fast Ethernet interfaces or a pair of Gigabit Ethernet interfaces) and can use any port other than fe-{0,2}/0/7.
In a J Series chassis cluster, you can configure any pair of Gigabit Ethernet interfaces to serve as the fabric between nodes.
You cannot configure filters, policies, or services on the fabric interface. Fragmentation is not supported on the fabric link. The maximum transmission unit (MTU) size is 8,980 bytes. We recommend that no interface in the cluster exceed this MTU. Jumbo frame support on the member links is enabled by default.
This topic includes:
Enter the following commands to join ge-0/0/1 on one node in the cluster and ge-7/0/1 on the other to form the fabric:
- {primary:node0}
- user@host# set interfaces fab0 fabric-options
member-interfaces ge-0/0/1
- {secondary:node1}
- user@host# set interfaces fab1 fabric-options
member-interfaces ge-7/0/1
