Enable PoE
|
From the [edit] hierarchy level:
- For all PoE interfaces user@host> set poe interface
all
- For specific PoE interfaces user@host> set poe interface
ge-0/0/
|
Enables a PoE interface. The PoE interface must be enabled in
order for the port to provide power to a connected powered device.
|
Disable PoE
|
From the [edit] hierarchy level:
- For all PoE interfaces ser@host> set poe interface
all disable
- For specific PoE interfaces user@host> set poe interface
ge-0/0/0 disable
|
Disables a PoE interface.
|
Set the power port priority
|
From the [edit] hierarchy level:
- For all PoE interfaces user@host> set poe interface
all priority low
- For specific PoE interfaces user@host> set poe interface
ge-0/0/0 priority high
|
Sets the priority of individual ports. When it is not possible
to maintain power to all connected ports, lower-priority ports are
powered off before higher-priority ports. When a new device is connected
on a higher-priority port, a lower-priority port will be powered off
automatically if available power is insufficient to power on the higher-priority
port.
Note:
For the ports with the same priority configuration, ports on
the left are given higher priority than the ports on the right.
|
Set the maximum PoE wattage available power for a port
|
From the [edit] hierarchy level:
- For all PoE interfaces user@host> set poe interface
all maximum-power 14
- For specific PoE interfaces user@host> set poe interface
ge-0/0/0 maximum power 12.8
Note:
The default wattage per port is 15.4 watts.
|
Sets the maximum amount of power that can be supplied to the
port.
|
Enable logging of PoE power consumption with the default telemetries
settings
|
From the [edit] hierarchy level:
- For all PoE interfaces user@host> set poe interface
all telemetries
- For specific PoE interfaces user@host> set poe interface
ge-0/0/0 telemetries
|
Allows logging of per-port PoE power consumption. The telemetries
section must be explicitly specified to enable logging. If left unspecified,
telemetries is disabled by default.
Default values for telemetries:
- Duration: 1 hour
- Interval: 5 minutes
|
Set the PoE power management mode
|
From the [edit] hierarchy level:
- set poe management classuser@host> set poe management
class
- set poe management static user@host> set poe management
static
|
- Class—When a powered device is connected to a PoE
port, the power allocated to it is equal to the maximum power for
the class as defined by the IEEE 802.3 AF standard.
- Static—When a powered device is connected to a PoE
port, the power allocated to it is equal to the maximum power configured
for the port.
|
Reserve a specified wattage of power for the gateway in case
of a spike in PoE consumption (default is 0)
|
From the [edit] hierarchy level:
For all PoE interfaces user@host> set poe guard-band 15
|
Reserves the specified amount of power for the gateway in case
of a spike in PoE consumption.
|
