You can use the Users Quick Configuration page for TACACS+ servers
to configure a TACACS+ server for system authentication. This Quick
Configuration page allows you to specify the IP address and secret
of the TACACS+ server.
Figure 5 shows the Users Quick Configuration
page for TACACS+ servers.
Figure 5: Users Quick Configuration Page for
TACACS+ Servers
To configure a TACACS+ server with Quick Configuration:
In the J-Web interface, select Configuration>Quick
Configuration>Users.
Under TACACS+ servers, click Add to configure a TACACS+ server.
Enter information into the Users Quick Configuration
page for TACACS+ servers, as described in Table 47.
Click one of the following buttons on the Users
Quick Configuration page for TACACS+ servers:
To apply the configuration and return to the Users Quick
Configuration page, click OK.
To cancel your entries and return to the Users Quick Configuration
page, click Cancel.
Table 47: Users Quick Configuration
for TACACS+ Servers Summary
Field
Function
Your Action
TACACS+
Server
TACACS+ Server Address (required)
Identifies the IP address of the TACACS+ server.
Type the TACACS+ server’s 32-bit IP address, in dotted
decimal notation.
TACACS+ Server Secret (required)
The secret (password) of the TACACS+ server.
Type the secret (password) of the TACACS+ server. Secrets can
contain spaces. The secret used must match that used by the TACACS+
server.
Verify TACACS+ Server Secret (required)
Verifies the secret (password) of the TACACS+ server is entered
correctly.
