You can use the Users Quick Configuration page for RADIUS servers
to configure a RADIUS server for system authentication. This Quick
Configuration page allows you to specify the IP address and secret
(password) of the RADIUS server.
Figure 4 shows the Users Quick Configuration
page for RADIUS servers.
Figure 4: Users Quick Configuration Page for
RADIUS Servers
To configure a RADIUS server with Quick Configuration:
In the J-Web interface, select Configuration>Quick
Configuration>Users.
Under RADIUS servers, click Add to configure a RADIUS server.
Enter information into the Users Quick Configuration
page for RADIUS servers, as described in Table 46.
Click one of the following buttons on the Users
Quick Configuration page for RADIUS servers:
To apply the configuration and return to the Users Quick
Configuration page, click OK.
To cancel your entries and return to the Users Quick Configuration
page, click Cancel.
Table 46: Users Quick Configuration
for RADIUS Servers Summary
Field
Function
Your Action
RADIUS
Server
RADIUS Server Address (required)
Identifies the IP address of the RADIUS server.
Type the RADIUS server’s 32-bit IP address, in dotted
decimal notation.
RADIUS Server Secret (required)
The secret (password) of the RADIUS server.
Type the secret (password) of the RADIUS server. Secrets can
contain spaces. The secret used must match that used by the RADIUS
server.
Verify RADIUS Server Secret (required)
Verifies the secret (password) of the RADIUS server is entered
correctly.
