To verify that a device is configured for autoinstallation, perform the following task.
Display the status of the autoinstallation feature on a device.
From the CLI, enter the show system autoinstallation status command.
user@host> show system autoinstallation status
Autoinstallation status: Master state: Active Last committed file: None Configuration server of last committed file: 10.25.100.1 Interface: Name: ge-0/0/0 State: Configuration Acquisition Acquired: Address: 192.168.124.75 Hostname: host-ge-000 Hostname source: DNS Configuration filename: router-ge-000.conf Configuration filename server: 10.25.100.3 Address acquisition: Protocol: DHCP Client Acquired address: None Protocol: RARP Client Acquired address: None Interface: Name: ge-0/0/1 State: None Address acquisition: Protocol: DHCP Client Acquired address: None Protocol: RARP Client Acquired address: None
The output shows the settings configured for autoinstallation. Verify that the values displayed are correct for the device when it is deployed on the network.