A Commands > address receive version

address receive version

Description: 

Restricts the RIP version that the router can receive on an interface. The no version sets the interface back to the default value, receiving both RIP version 1 and version 2.

Syntax: 

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
receive version { 1 | 2 | 1 2 | 2 1 | off }

no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ] receive version

• ipAddress—Address of IP interface where RIP will be run
• unnumbered—Specifies that RIP will be run on an unnumbered interface

• interfaceType—Interface type; see Interface Types and Specifiers in About This Guide
• interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in About This Guide

• 1—Specifies RIP version 1 only
• 2—Specifies RIP version 2 only
• 1 2—Specifies RIP version 1 and version 2; the default value
• 2 1—Specifies RIP version 2 and version 1
• off—Turns reception off

Mode(s): 

Interface Configuration, Subinterface Configuration