O-P-Q-R Commands > ospf log-adjacency-changes

ospf log-adjacency-changes

Description: 

Configures the router to send a system log message when the state of an OSPFv2 neighbor changes. For OSPFv3 neighbors, use the log-adjacency-changes command. The no version turns off this feature.

Syntax: 

[ no ] ospf log-adjacency-changes
[ severity { severityValue | severityNumber } ] [ verbosity verbosityLevel ]

• severity—Minimum severity of the log messages displayed for the selected category; described either by a descriptive term—severityValue—or by a corresponding number—severityNumber—in the range 0-7; the lower the number, the higher the priority:

• emergency or 0—System unusable
• alert or 1—Immediate action needed
• critical or 2—Critical condition exists
• error or 3—Error condition
• warning or 4—Warning condition
• notice or 5—Normal but significant condition
• info or 6—Informational message
• debug or 7—Debug message

• verbosityLevel—Specifies the verbosity of the log category's messages; can be any of the following:

• low—Terse
• medium—Moderate detail
• high—Verbose

Mode(s): 

Router Configuration