O-P-Q-R Commands > path

path

Description: 

Configures paths over channelized SONET and SDH interfaces. The no version deletes a path.

NOTE: Although the path speed appears to be optional in the software, you must specify a value.

Syntax: 

path pathChannel [ pathSpeed [ pathHierarchy ] ]

no path pathChannel

• pathChannel—Number in the range 1-2147483648 that identifies the STS-1 or STM-0 line
• pathSpeed—Speed of the path

• oc1, oc3, or oc12 for SONET—Only oc1 is available for cOC3/STM1 interfaces
• stm0, stm1, or stm4 for SDH—Only stm0 or stm1 is available for cOC3/STM1 interfaces

• pathHierarchy—Identifier that defines the structure of the path

• If you specify a path speed that matches the speed of the module (for example, a path speed of stm1 for a cOC3/STM1 interface), do not specify an identifier.
• If you specify a speed of oc1 or stm0 for a cOC3/STM1 interface, the identifier is a number in the range 1-3 that represents either the STS-1 within the STS-3 or the STM-0 within the STM-1.
• If you specify a speed of stm1 for a cOC12/STM4 interface, the identifier is a number in the range 1-4 that represents the STM-1 within the STM-4.
• If you specify a speed of oc1 or stm0 for a cOC12/STM4 interface, the identifier is of the form X/Y. X is a number in the range 1-4 that represents either the STS-3 within the STS-12 or the STM-1 within the STM-4; Y is a number in the range 1-3 that represents either the STS-1 within the STS-3 or the STM-0 within the STM-1.

Mode(s): 

Controller Configuration