Before You Configure IPv6

Before you configure IPv6, you must create the lower-layer interfaces over which IPv6 traffic flows.

Note: In this release, only ATM OC3/STM-1 and OC12/STM-4 I/O modules support IPv6 configuration.

For example, to configure an ATM interface:

host1(config)#interface atm 1/0

host1(config-if)#atm sonet stm-1

host1(config-if)#no loopback

host1(config-if)#atm clock internal chassis

host1(config-if)#interface atm 1/0.10

host1(config-if)#atm pvc 10 0 20 aal5snap

Refer to ERX Link Layer Configuration Guide, Chapter 1, Configuring ATM for information on configuring an ATM interface.