Disabling and Reenabling Modules

Disabling a line module or SRP module has the same effect as removing that module from a slot. A disabled module cannot operate, although its configuration remains in NVS. To allow the module to operate, you must reenable it.

    slot disable

• Use to disable the line module or SRP module in the specified slot.
• You can use this command to disable a module so that you can run diagnostic tests on the module.
• Example

host1(config)#slot disable 3

• There is no no version.

    slot enable

• Use to enable the line module or SRP module in the specified slot.
• Allows you to restart the module that was installed in the slot.
• The default is enable.
• Example

host1(config)#slot enable 3

• There is no no version.