Note: In this procedure we assume that the system is already connected to a power source. See Cabling the Router.
Note: Juniper Networks has qualified an AC power supply unit for use with the router. Contact your account representative for more information.
For specifications on the electrical requirements for the system, see System Specifications. For details on the power consumed by the different modules, see the E120 and E320 Module Guide.
Caution: Evaluate the overall loading of the branch circuit before you install any equipment into a rack.
To power up the system:
When the prompt appears on the system console, the system is in User Exec mode and is ready to be configured:
In Privileged Exec mode you can begin to configure the system. See JUNOSe System Basics Configuration Guide, Chapter 2, Command-Line Interface for more information.
Each line module is initialized independently. As a result, the CLI on the SRP module can become available before the line modules have completed initialization. Commands relating to a line module might fail if the module has not completed initialization. You can use the show version command to display line module status, but do not enter commands for a line module until its state is online.