Configuring Gigabit Ethernet Interfaces for IPv6 (SRC CLI)
You can configure the Gigabit Ethernet interfaces
to use IPv4 or IPv6 to allow remote access to the C Series Controller.
You can specify an IP address with mask or a broadcast address with
mask for an interface.
Use the following configuration statement to configure
Gigabit Ethernet interfaces to use IPv6 at the [edit] hierarchy
level:
interfaces name unit unit-number family inet6 address address;
To configure a Gigabit Ethernet interface
to use IPv6:
From configuration mode, access the configuration statement
that configures the interface.
[edit]
user@host# edit interfaces name unit unit-number
where unit-number is a number that you can assign for a logical interface identifier.
For example:
[edit]
user@host# edit interfaces eth0
Specify the unit, family, and IP address for the interface.
[edit interfaces eth0]
user@host# set unit number family inet6 address address
For example:
[edit interfaces eth0]
user@host# set unit 0 family inet6 address
2001:DB8:10AB:CD30::1/64
Verify the interface configuration.
[edit interfaces eth0]
user@host# show
unit 0 {
family {
inet6 {
address 10AB:0:0:CD30::/20;
}
}
}
