Powering On a JCS1200 Routing Engine

• You can press the power control button on the front of the Routing Engine behind the control panel door (see JCS1200 Routing Engine LEDs).

  Note: Wait until the power-on LED on the Routing Engine flashes slowly before you press the power control button. While the service processor in the management module is initializing, the power-on LED does not flash, and the power control button on the Routing Engine does not respond. While the Routing Engine is starting, the power-on LED on the front of the Routing Engine is lit.

• If a power failure occurs, the JCS1200 platform and then the Routing Engine can start automatically when power is restored if the Routing Engine is configured through the management module to do so.
• You can power on the Routing Engine remotely by issuing the power on -T system:blade[x] (where x is a value of 1 through 12) from the management module CLI. For more information, see the JCS1200 Routing Engine Power Command
• The wake-on-LAN feature can power on the Routing Engine if the following conditions are met:
  • The Routing Engine is connected to power (the power-on LED is flashing slowly).
  • The operating system supports the wake-on-LAN feature.
  • The wake-on-LAN feature has not been disabled through the management module.