TechLibrary

Navigation Back up to About Overview

Connecting the SRX220 Services Gateway to the Power Supply

Caution: Before connecting the device to the power supply, attach an electrostatic discharge (ESD) strap to an ESD point and place the other end of the strap around your bare wrist.

To connect the device to the power supply:

  1. Plug the DC connector end of the power cable into the power connector on the back of the device (see Figure 1).
  2. Secure the DC connector end of the power cable in the power connector, using a plastic cable tie, as shown in Figure 1.
  3. Plug the AC adapter end of the power cable into an AC power outlet.

    Figure 1: Connecting the SRX220 Services Gateway to the Power Supply

    Connecting the SRX220
Services Gateway to the Power Supply

Caution: We recommend using a surge protector for the power connection.

Note: Before the services gateway is fully configured and running, you might hear a crackling noise from the power supply unit. This noise is temporary and stops after the device is configured.

Published: 2013-06-23