Technical Documentation
Deactivating Alarms on the TX Matrix Plus Craft Interface
Deactivating an alarm turns off both LEDs and deactivates the device attached to the corresponding alarm relay contact on the TXP-CIP. The LCD continues to report the alarm message until the condition that caused the alarm is cleared.
To deactivate red and yellow alarms:
- Press the button labeled ACO/LT (for “alarm cutoff/lamp test”), which is located below the alarm LEDs.
- Look at the LCD for more information about the alarm or to confirm that the alarm has been cleared.
Published: 2011-12-19
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
