Replacing a JCS1200 Switch Module or Module Filler

Removing a JCS1200 Switch Module or Module Filler

Figure 1 shows how to remove and install a switch module.

Figure 1: Removing and Installing a JCS1200 Switch Module

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Pull the release handle to the open position. The module moves out of the bay approximately 0.25 in. (0.6 cm).
3. Slide the switch module out of the bay.

Installing a JCS1200 Switch Module or Module Filler

Figure 2 shows how to remove and install a switch module.

Figure 2: Removing and Installing a JCS1200 Switch Module

The JCS1200 platform ships with one switch module. You can install a second switch module for redundancy.

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Remove the switch module filler, if one is installed (see Removing a JCS1200 Switch Module or Module Filler).
3. Make sure that the release handle is in the open position.
4. Slide the switch module into the switch module interposer until it stops.
5. Push the switch module release handle to the closed position.
6. Connect the cables to the switch module.