Replacing an M10i Ethernet Management Cable

The MGMT port on the Routing Engine accepts Ethernet cable with and RJ-45 connector. For cable specifications, see Routing Engine Interface Cable and Wire Specifications for M10i Routers:

Figure 1: Routing Engine Ethernet Cable Connector

Figure 2: Ethernet Management Port

1. Removing a Management Ethernet Cable
2. Installing a Management Ethernet Cable

Removing a Management Ethernet Cable

1. Press the tab on the connector and pull the connector straight out of the port. Figure 1 shows the connector.
2. Disconnect the cable from the network device.

Installing a Management Ethernet Cable

1. Plug one end of the replacement Ethernet cable into the MGMT port. Figure 2 shows the ports on the routing engine.
2. Plug the other end of the cable into the network device.