Installing the CompactFlash Card in an M10i Routing Engine

To install the CompactFlash card (see Figure 1):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. If the CompactFlash card is in a PCMCIA card adapter, slide it out of the adapter.
3. Orient the CompactFlash card with the Juniper Networks logo facing up. Slide the CompactFlash card into the connector on the Routing Engine (see Figure 1).

   Note: If there is no Juniper Networks logo on the CompactFlash card, orient the CompactFlash card so that the manufacturer’s product code sticker is facing down.

4. Use needlenose pliers with grooved jaws to lower and secure the wire clasp.
5. Install the Routing Engine as described in Installing the M10i Routing Engine.

Figure 1: Inserting the CompactFlash Card