Technical Documentation
Installing the Mounting Hardware for the SRX3400 Services Gateway
The specific mounting hardware used depends on the type of rack being utilized. Use the appropriate procedure steps to install the mounting hardware for your situation.
To install the mounting hardware:
- Locate the rack mount brackets in the accessory kit.
- Use the screws provided to secure the rack mount
brackets to the sides of the chassis:
- For a two-post rack, mount the brackets at the mid-mount
holes, as shown in Figure 1.
Warning: When you install the services gateway in a two-post rack, you must attach the mounting brackets at the middle of each chassis side, as shown in Figure 1. Do not attempt to install the services gateway in a two-post rack with the mounting brackets attached at the front of the chassis. Such an installation might overstress either the brackets or the rack, causing the chassis to fall and inflict injury.
Figure 1: Attaching Mounting Hardware for Two-Post Rack
- For a four-post rack, mount the brackets near the front edge of the chassis, as shown in Figure 2.
Figure 2: Attaching Mounting Hardware for Cabinet or Four-Post Rack
- For a two-post rack, mount the brackets at the mid-mount
holes, as shown in Figure 1.
- For installation in a cabinet or a four-post rack, install the
support shelf on the rear posts, as shown in Figure 3.
Figure 3: Attaching Four-Post and Cabinet Support Shelf
