Technical Documentation
Related Documentation
- JCS 1200
- Preventing Electrostatic Discharge Damage to the JCS1200 Platform
- Tools and Parts Required to Install the JCS1200 Platform Without a Mechanical Lift
- Removing a JCS1200 Fan Module
- Removing a JCS1200 Fan Shuttle
- Removing a JCS1200 Management Module or Module Filler
- Removing a JCS1200 Media Tray
- Removing a JCS1200 Power Module
- Removing a JCS1200 Routing Engine
- Removing a JCS1200 Switch Module or Module Filler
- Installing the JCS1200 Platform Without Using a Lift
Removing Components from the JCS1200 Platform
Before lifting the JCS1200 platform, you must remove the following components:
- Fan modules
- Fan shuttle
- Management modules
- Media trays
- Power modules
- Routing Engines
- Switch modules
 | Note: For detailed instructions on removing JCS1200 components, see the removal procedures for each component. |
To remove the components from the JCS1200 platform:
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Slide each component out of the chassis evenly so that it does not become stuck or damaged.
- Label each component as you remove it so you can reinstall it in the correct location.
- Immediately store each removed component in an electrostatic bag.
- Do not stack removed components. Lay each one on a flat surface.
Related Documentation
- JCS 1200
- Preventing Electrostatic Discharge Damage to the JCS1200 Platform
- Tools and Parts Required to Install the JCS1200 Platform Without a Mechanical Lift
- Removing a JCS1200 Fan Module
- Removing a JCS1200 Fan Shuttle
- Removing a JCS1200 Management Module or Module Filler
- Removing a JCS1200 Media Tray
- Removing a JCS1200 Power Module
- Removing a JCS1200 Routing Engine
- Removing a JCS1200 Switch Module or Module Filler
- Installing the JCS1200 Platform Without Using a Lift
Published: 2011-12-15
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
