Replacing the T1600 Standard Rear Fan Tray

The rear fan tray is mounted vertically on the right side of the rear of the chassis. The standard rear fan tray contains eight fans, and is not interchangeable with the front fan trays. The standard rear fan tray must be used in conjunction with the standard front fan trays. The standard rear fan tray weighs about 10 lb (4.5 kg).

1. Removing the Standard T1600 Rear Fan Tray
2. Installing the Standard T1600 Rear Fan Tray

Removing the Standard T1600 Rear Fan Tray

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to an approved site ESD grounding point.
2. Loosen the captive screws on the top and bottom of the fan tray faceplate.
3. Grasp the handles, and pull the fan tray halfway out of the chassis.
4. Wait for the fans to stop spinning.
5. After the fans stop spinning, place one hand under the fan tray to support it, and pull the fan tray completely out of the chassis.

Figure 1: Removing the Rear Fan Tray

Installing the Standard T1600 Rear Fan Tray

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
2. Grasp the fan tray by its handles and insert it straight into the chassis.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis, using a Phillips (+) screwdriver, number 2.

Figure 2: Installing the Rear Fan Tray