Technical Documentation
Replacing a Management Ethernet Cable
Removing the Managment Ethernet Cable
To connect the Routing Engine to a network, connect an Ethernet cable with RJ-45/RJ-45 connectors to the ETHERNET port on the TXP-CIP. One cable is provided with the TX Matrix Plus router.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Press the tab on the connector and pull the connector straight out of the port. Figure 2 shows the connector.
- Disconnect the cable from the network device.
Installing the Management Ethernet Cable
To connect the Routing Engine to a network, connect an Ethernet cable with RJ-45/RJ-45 connectors to the ETHERNET port on the TXP-CB.
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Plug one end of the replacement Ethernet cable into the appropriate ETHERNET port. Figure 1 shows the external device ports on the TXP-CB.
- Plug the other end of the cable into the network device.
Figure 1: TXP-CB Management Ethernet Port
Figure 2: Ethernet Cable Connector
Published: 2011-12-19
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
