Technical Documentation
Installing the Cable Management System on a QFX3008-I Interconnect Device
The cable management system is located at the top front of the chassis, above the card cage. The cable management system is an optional field-replaceable unit (FRU).
Before you begin, ensure that you have the following parts and tools available to install the cable management system on a QFX3008-I Interconnect device:
- Electrostatic discharge (ESD) grounding strap
- Phillips (+) screwdriver, number 1
- Eight mounting screws, size 6-32 x 3/8” (included with the cable management system)
To install the cable management system on a QFX3008-I Interconnect device (see Figure 1):
- Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
- Place the cable management system on the chassis, aligning the holes on its faceplate with the mounting holes on the chassis.
- Install each of the mounting screws, tightening them by turning them clockwise using the Phillips (+) screwdriver, number 1.
Figure 1: Installing the Cable Management System on a QFX3008-I Interconnect Device
Published: 2012-03-23
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
