- Download
Software
- Research a
Problem - Case Management
- Communities and Forums
- Contract & Product Management
- Technical Documentation Advanced Search
- Documentation Feedback Form
- Documentation Symbols Key
- End-of-Life Products
- Guidelines and Policies
- Security Resources
Juniper was the first North American IP routing vendor to achieve the prestigious TL 9000 certification by the Quality of Excellence for Suppliers of Telecommunications (QuEST) Forum in the router category, for design, development, provision and service and support.
What is J-Care?
It's the world-class service and support that you expect from a company that delivers the industry's best infrastructure and security products. With J-Care, you now have the confidence knowing that Juniper will do our part to keep you on top of the world!
Signal Loss in Multimode and Single-Mode Fiber-Optic Cable for MX Series Routers
Multimode fiber is large enough in diameter to allow rays of light to reflect internally (bounce off the walls of the fiber). Interfaces with multimode optics typically use LEDs as light sources. LEDs are not coherent sources, however. They spray varying wavelengths of light into the multimode fiber, which reflects the light at different angles. Light rays travel in jagged lines through a multimode fiber, causing signal dispersion. When light traveling in the fiber core radiates into the fiber cladding, higher-order mode loss (HOL) results. Together these factors limit the transmission distance of multimode fiber compared to single-mode fiber.
Single-mode fiber is so small in diameter that rays of light can reflect internally through one layer only. Interfaces with single-mode optics use lasers as light sources. Lasers generate a single wavelength of light, which travels in a straight line through the single-mode fiber. Compared with multimode fiber, single-mode fiber has higher bandwidth and can carry signals for longer distances. It is consequently more expensive.
For information about the maximum transmission distance and supported wavelength range for the types of single-mode and multimode fiber-optic cable used by DPCs on the MX Series routers, see the MX Series Ethernet Services Routers DPC Guide. For information about the maximum transmission distance and supported wavelength range for the types of single-mode and multimode fiber-optic cable used by PICs on the MX Series routers, see the MX Series Ethernet Services Routers PIC Guide. Exceeding the maximum transmission distances can result in significant signal loss, which causes unreliable transmission.
