Skip to content

Support



Juniper was the first North American IP routing vendor to achieve the prestigious TL 9000 certification by the Quality of Excellence for Suppliers of Telecommunications (QuEST) Forum in the router category, for design, development, provision and service and support.



What is J-Care?

It's the world-class service and support that you expect from a company that delivers the industry's best infrastructure and security products. With J-Care, you now have the confidence knowing that Juniper will do our part to keep you on top of the world!


JCS1200 Alarm Panel Module Connectors and LEDs

Figure 1 shows the location of LEDs and connectors on the alarm panel module.

Figure 1: JCS1200 Alarm Panel Module LEDs and Connectors

Image bb1cp041.gif

The JCS1200 alarm panel module consists of the following components:

  • Serial connector—This DB-60 connector provides direct access to the serial ports on each of the 12 Routing Engine bays. Use this connector to attach the optional serial port breakout cable and connect up to 12 local consoles.
  • Telco alarm connector—The alarm panel module provides one DB-15 connector (male) for critical, major, and minor telco alarms. Each of the alarms has a relay that enables multiple system alarm indicators to be daisy-chained together.
  • LEDs—The alarm panel module contains seven LEDs. Table 1 describes the function of each LED.

Table 1: JCS1200 Alarm Panel Module LEDs

Name

Color

State

Description

Power-on

Green

On steadily

Power is present in the JCS1200 platform.

–

Off

The power subsystem, the power module, or the LED has failed.

Caution: If the power-on LED is off, it does not mean that no electrical current is present in the JCS1200 platform. The LED might be defective. To remove all electrical current from the JCS1200 platform, you must disconnect all power cords from the rear power connectors.

Location

Blue

On steadily or flashing

Indicates that the LED has been turned on by the system administrator, to aid in visually locating the JCS1200 platform. After the JCS1200 platform has been located, you can have the system administrator turn off the location LED.

Critical system fault

Amber or red

Note: The color of this LED can be set to amber or red through the management module.

On steadily

The JCS1200 platform has a critical system fault. A critical system fault is an error or event that is detected by the system and that has a significant impact to the system. In this case, the system cannot continue to operate or is operating in a nonredundant power or cooling configuration.

Major system fault

Amber or red

Note: The color of this LED can be set to amber or red through the management module.

On steadily

The JCS1200 platform has a major system fault. The system can continue to operate but may lose some functionality and performance.

Minor system fault

Amber

On steadily

The JCS1200 platform has a minor system fault. The system can continue to operate, usually without noticeable loss of functionality or performance.

FRU ready for removal

Blue

On steadily

It is safe to remove the alarm panel module from the JCS1200 platform.

Alarm panel module fault

Amber

On steadily

Indicates that there is a fault on the alarm panel module. The system can continue to operate, usually without the use of the components on the alarm panel module.

Published: 2009-08-06