Technical Documentation
Related Documentation
- JCS 1200
- Returning a Hardware Component to Juniper Networks, Inc.
- M Series
- Returning a Hardware Component to Juniper Networks, Inc.
- MX Series
- Returning a Hardware Component to Juniper Networks, Inc.
- T Series
- T1600 Chassis Description
- T1600 Router Description
- Returning a Hardware Component to Juniper Networks, Inc.
Tools and Parts Required for Replacing T1600 Hardware Components
To replace hardware components, you need the tools and parts listed in Table 1.
Table 1: Tools and Parts Required for Component Replacement
Components | Tool or part |
|---|---|
All | Electrostatic discharge (ESD) grounding wrist strap |
AC power supply Three-phase delta AC power supply or three-phase wye AC power supply | Phillips (+) screwdrivers, number 2 to access the metal AC wiring compartment 1/4-in. slotted screwdriver to attach the ground wire and input terminal wires of the AC power cord. |
Air filter (front or rear) | Phillips (+) screwdrivers, numbers 1 and 2 |
CIP | Phillips (+) screwdrivers, numbers 1 and 2 |
Craft interface | Phillips (+) screwdrivers, numbers 1 and 2 |
DC power supply Three-input 240-A DC power supply or Four-input 240-A DC power supply | Phillips (+) screwdrivers, numbers 1 and 2 7/16-in. (11 mm) nut driver Caution: You must use an appropriate torque-controlled tool to tighten the nuts. Applying excessive torque damages the terminal studs and the power supply. The absolute maximum torque that may be applied to this nut is 45 in-lb (5.0 Nm). Flashlight Nonconductive sharp object |
DC power supply cable | 7/16-in. (11 mm) nut driver Caution: You must use an appropriate torque-controlled tool to tighten the nuts. Applying excessive torque damages the terminal studs and the power supply. The absolute maximum torque that may be applied to this nut is 45 in-lb (5.0 Nm). |
Fan tray (front or rear) | Phillips (+) screwdrivers, numbers 1 and 2 |
FPC | Phillips (+) screwdrivers, numbers 1 and 2 Blank panel (if component is not reinstalled) Electrostatic bag or antistatic mat |
PIC | Phillips (+) screwdrivers, numbers 1 and 2 Rubber safety cap for fiber-optic PICs or fiber-optic PIC cables Flat-blade (–) screwdriver for Type 1 PICs Electrostatic bag or antistatic mat Blank panel (if component is not reinstalled) |
Routing Engine | Phillips (+) screwdrivers, numbers 1 and 2 Electrostatic bag or antistatic mat Blank panel (if component is not reinstalled) |
Serial cable to AUXILIARY or CONSOLE Routing Engine port | Flat-blade (–) screwdriver |
T1600-SIB | Phillips (+) screwdrivers, numbers 1 and 2 Electrostatic bag or antistatic mat Blank panel (if component is not reinstalled) |
SCG | Phillips (+) screwdrivers, numbers 1 and 2 |
T-CB or LCC-CB | Phillips (+) screwdrivers, numbers 1 and 2 Electrostatic bag or antistatic mat Blank panel (if component is not reinstalled) |
Related Documentation
- JCS 1200
- Returning a Hardware Component to Juniper Networks, Inc.
- M Series
- Returning a Hardware Component to Juniper Networks, Inc.
- MX Series
- Returning a Hardware Component to Juniper Networks, Inc.
- T Series
- T1600 Chassis Description
- T1600 Router Description
- Returning a Hardware Component to Juniper Networks, Inc.
