Technical Documentation
Related Documentation
- JCS 1200
- General Safety Guidelines for Juniper Networks Hardware Equipment
- M Series
- General Safety Guidelines for Juniper Networks Hardware Equipment
- MX Series
- General Safety Guidelines for Juniper Networks Hardware Equipment
- T Series
- Replacing a T1600 Three-Input 240-A DC Power Supply
- Replacing a T1600 Four-Input 240-A DC Power Supply
- T1600 DC Power Electrical Safety Guidelines
- General Safety Guidelines for Juniper Networks Hardware Equipment
Tools and Parts Required for Replacing T1600 DC Power System Components
To replace a DC power supply, you need the following tools and equipment:
- Phillips (+) screwdriver, number 2
- ESD wrist strap with cable
- 7/16-in. (11 mm) nut driver
Caution: You must use an appropriate torque-controlled tool to tighten the nuts. Applying excessive torque damages the terminal studs and the power supply. The absolute maximum torque that may be applied to this nut is 45 in-lb (5.0 Nm).
- Wire cutters
- Flashlight
- Flat-blade (–) screwdriver
Related Documentation
- JCS 1200
- General Safety Guidelines for Juniper Networks Hardware Equipment
- M Series
- General Safety Guidelines for Juniper Networks Hardware Equipment
- MX Series
- General Safety Guidelines for Juniper Networks Hardware Equipment
- T Series
- Replacing a T1600 Three-Input 240-A DC Power Supply
- Replacing a T1600 Four-Input 240-A DC Power Supply
- T1600 DC Power Electrical Safety Guidelines
- General Safety Guidelines for Juniper Networks Hardware Equipment
Published: 2011-12-20
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
