Technical Documentation
New
Related Documentation
- ACX Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- JCS 1200
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- M Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- MX Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- PTX Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- T Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
Preventing Electrostatic Discharge Damage to an MX240 Router
Many router hardware components are sensitive to damage from static electricity. Some components can be impaired by voltages as low as 30 V. You can easily generate potentially damaging static voltages whenever you handle plastic or foam packing material or if you move components across plastic or carpets. Observe the following guidelines to minimize the potential for electrostatic discharge (ESD) damage, which can cause intermittent or complete component failures:
- Always use an ESD wrist strap or ankle strap, and make
sure that it is in direct contact with your skin.
Caution: For safety, periodically check the resistance value of the ESD strap. The measurement should be in the range of 1 to 10 Mohms.
- When handling any component that is removed from the chassis, make sure the equipment end of your ESD strap is attached to one of the electrostatic discharge points on the chassis.
- Avoid contact between the component and your clothing. ESD voltages emitted from clothing can still damage components.
- When removing or installing a component, always place it component-side up on an antistatic surface, in an antistatic card rack, or in an electrostatic bagFigure 1 . If you are returning a component, place it in an electrostatic bag before packing it.
Figure 1: Placing a Component into an Electrostatic Bag
Related Documentation
- ACX Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- JCS 1200
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- M Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- MX Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- PTX Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
- T Series
- General Safety Guidelines for Juniper Networks Devices
- General Safety Warnings for Juniper Networks Devices
- Fire Safety Requirements for Juniper Networks Devices
Published: 2013-02-04
Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.
