Software release

• Junos OS Release 10.1 and later (Type 4)

  For information on which FPCs support this PIC, see T640 PIC/FPC Compatibility.

Note: In some Juniper Networks documentation, the 10-Gigabit Ethernet LAN/WAN PIC with SFP+ (PD-5-10XGE-SFPP) is referred to as the 10-port 10-Gigabit Oversubscribed Ethernet PIC. In oversubscribed Ethernet mode (default), all 10 ports are enabled and oversubscription is permitted. In line-rate mode, this PIC does not allow oversubscription and supports only 5 ports (0, 2, 4, 6, and 8).

Description

• 10 10-Gigabit Ethernet SFP+ ports (only ports 0, 2, 4, 6, and 8 are supported in line-rate mode)
• Total bandwidth: 50 Gbps
• Power requirements: 3.3 A @ –48 V (158.4 W)

Software features

• Two modes of operation: 5 ports in line-rate mode, 10 ports in oversubscribed mode
• Intelligent handling of oversubscribed traffic
• Flexible mapping of port-assigned queues and scheduler resources at both ingress and egress
• Strict-priority queue available on a per-port basis
• QoS available on a per-port basis
• Weighted round robin (WRR)
• L2 Protocol support:
  • Ethernet CCC, Ethernet TCC, Ethernet VPLS
  • VLAN CCC
  • Extended VLAN TCC
  • VLAN VPLS
  • Flexible-Ethernet-services
• L3 Protocol support
  • IPv4
  • IPv6
  • MPLS
• VLAN support
  • 4K VLANs per PIC
  • Flex-VLAN tagging support
  • Interrupt driven link-down detection
  • Pause frame support
  • Jumbo frame support
• IEEE 802.3ad Link Aggregation
• MAC learning, aging, and filtering
• Virtual Router Redundancy Protocol (VRRP) support
• Aggregated Ethernet (For routers in a routing matrix, Junos OS Release 11.2 and later is required)

  Note: The PIC must be in line-rate mode to support aggregated Ethernet.

• MAC policer
• DSCP rewrite is supported for Junos OS Release 11.4 and later.

LEDs

• Off—PIC is offline and safe to remove from the router.
• Green—PIC is operating normally.
• Yellow—PIC is initializing.
• Red—PIC has an error or failure.

• LINK LED

  • Off—Port is not enabled.
  • Green—Port is online with no alarms or failures.
  • Red—The router has detected a failure with alarms.

• ACT LED

  • Green flashing—Port is sending or receiving packets.
  • Off—No packet activity detected on the port.