Rate and give feedback:
Feedback Received. Thank You!
10-Gigabit Ethernet PIC with XENPAK (T640 Router)
Software release | - Junos OS Release 6.2 and later (Type 3): 10GBASE-ER and
10GBASE-ZR transceivers
- Junos OS Release 7.1 and later (Type 3): 10GBASE-SR and
10GBASE-ZR transceivers
For information on which FPCs support this PIC, seeT640 PIC/FPC Compatibility . |
Description | - One 10-Gigabit Ethernet port
- Power requirement: 0.55 A @ 48 V (26.6 W)
- Supports large Ethernet frame sizes for more efficient
throughput across the intra-POP network
|
Hardware features | - High-performance throughput at speeds up to 10 Gbps
- Full-duplex mode
- Maximum transmission units (MTUs) up to 9192 bytes
- 64 source MAC address filters
- 960 destination MAC filters
|
Software features | - Virtual Router Redundancy Protocol (VRRP) support
- 802.1q virtual LANs (VLANs) support
- 802.3ae link aggregation support
- RMON EtherStats
- Optical diagnostics and related alarms (Junos OS Release
8.1 and later):
- Transceiver temperature
- Laser bias current
- Laser output power
- Receive optical power
|
Cables and connectors | - Duplex SC/PC connector (RX and TX)
|
LEDs | Status LED, one bicolor: - Off—PIC not enabled.
- Green—PIC is operating normally.
- Red—PIC has an error or failure.
Port LEDs, one pair: - Link—If green, the port is online; if there is no
light, the port is down.
- RX—If flashing green, the port is receiving data;
if there is no light, the port might be on but is not receiving data.
|
Published: 2011-03-01
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
