Rate and give feedback:
Feedback Received. Thank You!
100-Gigabit Ethernet PIC with CFP (T1600 Router)
Software release | - Junos OS Release 10.3 (Type 4)
|
Description | - One-port 100-Gigabit Ethernet PIC
|
Hardware features | - There are 2 physical interfaces when the 100 Gigabit Ethernet
PIC is online (ce-x/0/0:0 and ce-x/0/0:1, where
x represents the FPC slot number). Each physical interface represents
two internal 50 gigabit Ethernet PFEs. Two logical interfaces are
configured under each physical interface. PFE0 is physical interface 0, PFE1 is physical interface 1.
|
Software features | - MAC accounting
Layer 2 protocols: - Flexible Ethernet service
- Ethernet CCC
- Ethernet TCC
- Ethernet VPLS
- VLAN CCC
- Extended VLAN TCC
- VLAN VPLS
Layer 3 protocols: - Optical control features (vendor dependent).
- Flexible VLAN tagging
- VLAN rewriting
- 802.3 link aggregation
- Graceful Routing Engine switchover (GRES) is supported
in all PIC and chassis configurations.
|
Cables and connectors | |
LEDs | One bicolor LED
for the PIC status (on PIC 0): - Green—Online with no alarms or failures
- Yellow—Online with alarms for remote failures
- Off—Not enabled
RX LED (PiC 1): - Flashing green—Port is receiving data.
- Off—Port might be on, but is not receiving data.
TX LED (PiC 1): - Flashing green—Port is receiving data.
- Off—Port might be on, but is not receiving data.
|
Alarms, errors, and events | - Alarm indication signal (AIS)
- Laser bias current high/low alarms and warnings
- Laser Rx power high/low alarms and warnings
- Module not ready alarm
- Module power down alarm
- Module temperature high/low alarms and warnings
- Rx CDR loss of lock alarm
- Rx loss of signal alarm
- Rx not ready alarm
- Tx CDR loss of lock alarm
- Tx data not ready alarm
- Tx laser fault alarm
- Tx not ready alarm
|
Published: 2011-03-01
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
