Software release

• Junos 9.4 and later

Hardware features

• Rate policing on input
• Rate shaping on output
• Packet buffering, Layer 2 parsing

Cables and connectors

You can install any transceiver supported by the PIC. For information about installing and removing transceivers, see the hardware guide for your router.

• SONET/SDH OC48/STM12 small form-factor pluggable (SFP) transceivers:
  • Connector: Duplex LC/PC (Rx and Tx)
  • Short reach (SR-1) (model number: SFP-1OC48-SR)
  • Intermediate reach (IR-1) (model number: SFP-1OC48-IR)
  • Long reach (LR-2) (model number: SFP-1OC48-LR)

  Optical interface specifications—see SONET/SDH OC12/STM4 Optical Interface Specifications

Note: To extend the life of the laser, when a PIC is not being actively used with any valid links, take the PIC offline until you are ready to establish a link to another device. For information about taking a PIC offline, see the request chassis pic offline command in the Junos OS Operational Mode Commands.

Alarms, errors, and events

• SONET alarms:

  • Alarm indication signal—line (AIS-L)
  • Alarm indication signal—path (AIS-P)
  • Bit error rate—signal degrade (BERR-SD)
  • Bit error rate—signal fail (BERR-SF)
  • Bit interleaved parity (BIP) error B1, B2, B3
  • Far-end bit error: remote error indication—line (REI-L), far-end line coding violations (CV-LFE)
  • Far-end bit error: remote error indication—path (REI-P), far-end path coding violations (CV-PFE)
  • Loss of frame (LOF)
  • Loss of pointer (LOP-P)
  • Loss of signal (LOS)
  • Payload label mismatch (PLM-P)
  • Payload unequipped (unequipped STS at path level) (UNEQ-P)
  • Remote defect indication—line (RDI-L)
  • Remote defect indication—path (RDI-P)

• SDH alarms:

  • Administrative unit alarm indication signal (AU-AIS)
  • Bit error rate signal degrade (BERR-SD)
  • Bit error rate signal fail (BERR-SF)
  • Bit interleaved parity (BIP) error B1, B2, B3
  • Higher order path—payload label mismatch (HP-PLM)
  • Higher order path—loss of pointer (HP-LOP)
  • Higher order path—remote defect indication (HP-RDI)
  • Higher order path—unequipped (HP-UNEQ)
  • Loss of frame (LOF)
  • Loss of signal (LOS)
  • Multiplex section—alarm indication signal (MS-AIS)
  • Multiplex section—remote defect indication (MS-RDI)
  • Multiplex section—remote error indication (MS-REI)

• Error detection:

  • Errored seconds (ES-S, ES-L, ES-P)
  • Far-end errored seconds (ES-LFE, ES-PFE)
  • Far-end severely errored seconds (SES-LFE, SES-PFE)
  • Far-end unavailable seconds (UAS-LFE, UAS-PFE)
  • Severely errored framing (SEF)
  • Severely errored framing seconds (SEFS-S)
  • Severely errored seconds (SES-S, SES-L, SES-P)
  • Unavailable seconds (UAS-L, UAS-P)