Rate and give feedback:
Feedback Received. Thank You!
ATM2 DS3 IQ PIC (M320 Router)
Description | - Four DS3 ports
- Power requirement: 0.41 A @ 48 V (20.0 W)
- Fine-grained queuing per logical interface
- ATM standards compliant
|
Hardware features | - 16-MB SDRAM memory for ATM segmentation and reassembly
(SAR)
- ATM switch ID
- Configurable framing options:
- C-bit with ATM direct mapping
- C-bit with Physical Layer Convergence Protocol (PLCP)
framing (default)
- M23 ATM direct mapping
- M23 with PLCP framing
- Internal and loop timing
|
Software features | - Per-virtual circuit (VC) and per-virtual path (VP) traffic
shaping
- Unspecified bit rate (UBR) traffic shaping
- Fine-grained variable bit rate (VBR) traffic shaping
- Circuit cross-connect (CCC)
- ATM Inverse Address Resolution Protocol (ARP), which enables
routers to automatically learn the IP address of the router on the
far end of an ATM permanent virtual circuit (PVC)
- Simple Network Management Protocol (SNMP):
- Management Information Base (MIB) 2 (RFC 1213)
- ATM MIB (RFC 1695)
- SONET MIB
- AAL5 encapsulations:
- ATM-VC-MUX
- ATM-NLPID
- ATM-Cisco-LLPID
- ATM-SNAP
- ATM-CCC-VC-MUX
|
Cables and connectors | - 10 ft (3.05 m) posilock SMB to BNC (provided)
- Four pairs of Rx and Tx coaxial cables
|
LEDs | One tricolor per port: - Off—Not enabled
- Green—Online with no alarms or failures
- Yellow—Online with alarms for remote failures
- Red—Active with a local alarm; router has detected
a failure
|
Alarms, errors, and events | - Alarm indication signal (AIS)
- Far-end block error (FEBE)
- Frame error
- Idle code
- Idle received
- Local and remote loopback
- Loss of signal (LOS)
- Out of frame (OOF)
- Path parity error
- Yellow alarm
|
Published: 2012-03-21
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
