Rate and give feedback:
Feedback Received. Thank You!
10-Gigabit Ethernet PIC with XENPAK (M120 Router)
Software release | Note:
This PIC is not supported in Junos OS Release 8.1R1. |
Description | - One 10-Gigabit Ethernet port
- Power requirement: 0.55 A @ 48 V (26.6 W)
- Supports large Ethernet frame sizes for more efficient
throughput across the intra-POP network
|
Hardware features | - High-performance throughput at speeds up to 10 Gbps
- Full-duplex mode
- Maximum transmission units (MTUs) up to 9192 bytes
- 64 source MAC address filters
- 960 destination MAC filters
|
Software features | - Virtual Router Redundancy Protocol (VRRP) support
- 802.1q virtual LANs (VLANs) support
- 802.3ae link aggregation support
- RMON EtherStats
- Optical diagnostics and related alarms :
- Transceiver temperature
- Laser bias current
- Laser output power
- Receive optical power
|
Cables and connectors | Fiber-optic 10-Gigabit XENPAK transceivers: - Short Wavelength Serial (10GBase-SR), LAN Rate (model
number: XENPAK-1XGE-SR)
- Long Wavelength Serial (10GBase-LR), LAN Rate (model number:
XENPAK-1XGE-LR )
- Extra-Long Wavelength Serial (10GBase-ER), LAN Rate (model
number: XENPAK-1XGE-ER)
- Extra-Long Wavelength Serial (10GBase-ZR), LAN Rate (model
number: XENPAK-1XGE-ZR )
- Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface Specifications
|
LEDs | Status LED, one bicolor: - Off—PIC not enabled.
- Green—PIC is operating normally.
- Red—PIC has an error or failure.
Port LEDs, one pair: - Link—If green, the port is online; if there is no
light, the port is down.
- RX—If flashing green, the port is receiving data;
if there is no light, the port might be on but is not receiving data.
|
Published: 2011-08-04
Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.
