Technical Documentation

Download Software

Research a Problem

Case Management

Contract & Product Management

Technical Documentation

Documentation Archive

Enterprise MIBs

File Format Help

Portable Libraries

End-of-Life Products

Contact Support

Guidelines and Policies

Security Resources

Related Documentation

Channelized STM1 IQ PIC (M120 Router)

Image g003096.gif

Software release

Junos OS Release 8.0R2 and later (Type 1)
For information on which FPCs support this PIC, see M120 PIC/FPC Compatibility .

Note: This PIC is not supported in Junos OS Release 8.1R1.

Description	One STM1 port Power requirement: 0.39 A @ 48 V (18.6 W) Fine-grained queuing per logical interface Channelization: STM1c, fractional E1, framed and unframed DS0
Hardware features	Packet buffering, Layer 2 parsing Local and remote loopback testing
Software features	Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection (RED), weighted random early detection (WRED) SNMP: SONET/SDH MIB, T1/E1 MIB Dynamic, arbitrary channel configuration Full bit error rate test (BERT) patterns at E1 and DS0 levels Encapsulations: High-Level Data Link Control (HDLC) Frame Relay Circuit cross-connect (CCC) Translational cross-connect (TCC) Point-to-Point Protocol (PPP)
Cables and connectors	Duplex SC/PC connector (Rx and Tx); single-mode intermediate-reach fiber
LEDs	One tricolor per port: Off—Not enabled Green—Online with no alarms or failures Yellow—Online with alarms for remote failures Red—Active with a local alarm; router has detected a failure
Alarms, errors, and events	Alarm indication signal (AIS-L, AIS-P) Bit error rate signal degrade (BERR-SD), bit error rate signal fail (BERR-SF) Bit interleaved parity errors B1, B2, B3 (CV-S, CV-L, CV-P) Errored seconds (ES-S, ES-L, ES-P), far-end bit errors REI-L, REI-P (CV-LFE, CV-PFE), far-end errored seconds (ES-LFE, ES-PFE), far-end severely errored seconds (SES-LFE, SES-PFE), far-end unavailable seconds (UAS-LFE, UAS-PFE) Loss of frame (LOF), loss of pointer (LOP-P), loss of signal (LOS) Payload mismatch (PLM-P), payload unequipped (UNEQ-P) Remote defect indication (RDI-L, RDI-P) Severely errored framing (SEF), severely errored framing seconds (SEFS-S), severely errored seconds (SES-S, SES-L, SES-P), unavailable seconds (UAS-L, UAS-P)
Instrumentation (counters)	Layer 2 per-queue and per-channel packet and byte counters

Related Documentation

Published: 2011-08-04

Site Map / RSS Feeds / Careers / Accessibility / Feedback / Privacy & Policy / Legal Notices

Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.

|

|