Technical Documentation

Gigabit Ethernet PIC with SFP (M10i Router)

Software release	Junos OS Release 6.3 and later For information on which CFEBs support this PIC, seeM10I PIC/CFEB Compatibility.
Description	One Gigabit Ethernet port Power requirement: 0.15 A @ 48 V (7.3 W) Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network
Hardware features	High-performance throughput on each port at speeds up to 1 Gbps Autonegotiation between Gigabit Ethernet circuit partners Full-duplex mode Maximum transmission units (MTUs) of up to 9192 bytes
Software features	Virtual Router Redundancy Protocol (VRRP) support 802.1q virtual LANs (VLANs) support 960 destination MAC filters per port Flexible Ethernet encapsulation Multiple tag protocol identifiers (TPID) support Source MAC learning MAC accounting and policing—Dynamic local address learning of source MAC addresses
Cables and connectors	You can install any transceiver supported by the PIC. Fiber-optic SFP transceivers: Duplex LC/PC connector (Rx and Tx) Note: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize the SFP.
LEDs	Status LED, one bicolor: Off—PIC is not enabled. Green—PIC is operating normally. Red—PIC has an error or failure. Port LEDs, one pair per port: Link—If green, the port is online; if there is no light, the port is down. Activity—If flashing green, the port is receiving data; if there is no light, the port might be on but is not receiving data.