Technical Documentation

Download Software

Research a Problem

Case Management

Contract & Product Management

Technical Documentation

Documentation Archive

Enterprise MIBs

File Format Help

Portable Libraries

End-of-Life Products

Contact Support

Guidelines and Policies

Security Resources

Related Documentation

10-Gigabit Ethernet Enhanced Ethernet Services DPC with XFP

Software release	Junos OS Release 8.4 and later
Description	Four 10-Gigabit Ethernet ports Power requirement: 6.46 A @ 48 V (310 W) Weight: 13.1 lb (5.9 kg) Model number: DPCE-X-4XGE-XFP
Hardware features	High-performance throughput on each port at speeds up to 10 Gbps WAN-PHY mode at 9.953 Gbps LAN-PHY mode at 10.3125 Gbps Full-duplex mode Maximum transmission units (MTUs) of up to 9192 bytes Enhanced ASICs for increased performance and scalability of Layer 2 features
Software features	Configurable WAN-PHY mode options See Protocols and Applications Supported by Enhanced Ethernet Services DPCs (DPCE-X) for information about the protocols and applications that this DPC supports. Note: The routing table is limited to 32,000 IP routes. This limitation applies to any manner in which the routes are learned, such as OSPF, RIP, and so on. The DPC supports BGP for L2 VPNs only.
Cables and connectors	You can install any transceiver supported by the DPC. For information about installing and removing transceivers, see the hardware guide for your router. Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers: Connector: Duplex LC/PC (Rx and Tx) 10GBASE-E (model number: XFP-10G-E-OC192-IR2) 10GBASE-L (model number: XFP-10G-L-OC192-SR1) 10GBASE-S (model number: XFP-10G-S) 10GBASE-Z (model number: XFP-10G-Z-OC192-LR2) Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface Specifications DWDM Tunable XFP transceivers: Connector: Duplex LC/PC (Rx and Tx) 10GBASE-ZR (model number: XFP-10G-CBAND-T50-ZR) DWDM supported wavelengths—see 10-Gigabit Ethernet DWDM Transceiver Wavelengths Note: XFP-10G-CBAND-T50-ZR is supported in Junos OS Release 10.2 and later Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface Specifications
LEDs	OK/FAIL LED, one bicolor: Steady green—DPC is functioning normally. Blinking green—DPC is transitioning online or offline. Red—DPC has failed. TUNNEL LED, one green per port: Off—Normal operating mode. On steadily—Port configured in tunnel mode. LINK LED, one green per port: Off—No link. On steadily—Link is active. The TUNNEL and LINK LEDs are labeled top to bottom 0/0 through 3/0.

Related Documentation

Published: 2011-12-21

Site Map / RSS Feeds / Careers / Accessibility / Feedback / Privacy & Policy / Legal Notices

Copyright© 1999-2012 Juniper Networks, Inc. All rights reserved.

|

|