SRX3600 Services Gateway NEBS and ETSI Compliance

SRX3600 Services Gateway NEBS and ETSI Standards

The SRX3600 Services Gateway, when installed and configured as described in this section, meets the following NEBS and ETSI standards:

• GR-63-CORE
• ETSI 300019-2-1
• ETSI 300019-2-2
• ETSI 300019-2-3
• GR-1089-CORE

SRX3600 Services Gateway NEBS and ETSI Configuration Requirements

To meet the NEBS and ETSI standards described in SRX3600 Services Gateway NEBS and ETSI Standards, the SRX3600 Services Gateway must be configured as follows:

• The services gateway must be installed in an open two-post or four-post rack, and not in an enclosed cabinet.
• The services gateway must be installed in accordance with the instructions and procedures in this guide.
• The services gateway must be equipped with four power supplies.
• For AC-powered services gateways, all four power supplies installed in the device must be Revision 09 or later. You can determine the power supply version numbers by using the show chassis hardware command. You can also identify the power supply version by referring to the printed label on the power supply, which shows the version in an alphabetic format. Revision 09 corresponds to “REV 0F,” Revision 10 corresponds to “REV 0G,” and so on. Figure 1 shows the location of the power supply model and revision label.

  Figure 1: Power Supply Model and Revision Label (AC Shown, DC Similar)

  
• For DC-powered services gateways, all four power supplies installed in the device must be enhanced DC power supplies. You can determine the power supply type by using the show chassis hardware command. You can also identify the power supply type by referring to the printed label on the power supply, as shown in Figure 1. Standard DC power supplies are identified on the label as model “DS850DC.” Enhanced DC power supplies are identified as “DS1200DC-3-401.”
• The services gateway must not have any two SPCs installed side by side in the CFM slots in the front of the chassis (CFM slots 1 through 6). You can install SPCs side by side in the CFM slots in the rear of the chassis (CFM slots 7 through 12).
• All SFP and XFP transceivers installed in the services gateway must be of extended temperature (ET) type. Table 1 describes the applicable transceivers available from Juniper Networks.

  Table 1: Extended Temperature SFP and XFP Transceivers

  SKU	Description
  SRX-SFP-1GE-LH-ET	1000BASE-LH SFP optical transceiver
  SRX-SFP-1GE-LX-ET	1000BASE-LX SFP optical transceiver
  SRX-SFP-1GE-SX-ET	1000BASE-SX SFP optical transceiver
  SRX-SFP-1GE-T-ET	1000BASE-T SFP copper transceiver
  SRX-XFP-10GE-ER-ET	10GBASE-ER XFP optical transceiver
  SRX-XFP-10GE-LR-ET	10GBASE-LR XFP optical transceiver
  SRX-XFP-10GE-SR-ET	10GBASE-SR XFP optical transceiver