1-Port SFP Mini-Physical Interface Module Key Features

• Enables you to install and remove transceivers without powering down the device
• Provides real-time visual status of connectivity and traffic flows
• Provides Link Up/Down alarm
• Supports the following transceiver types:
  • 1000BASE-SX
  • 100BASE-LX
  • 1000BASE-LX10
  • 100BASE-FX
  • 1000BASE-T
  • 1000BASE-LH (ZX)
  • Tri-Rate 10/100/1000BASE-T, Copper Transceiver
  • 1000BASE-BX10, at 10 km (TX1310 nm / RX1490 nm)
  • 1000BASE-BX10, at 10 km (TX1310 nm / RX1550 nm)
  • 1000BASE-BX10, at 10 km (TX1490 nm / RX1310 nm)
  • 1000BASE-BX10, at 10 km (TX1550 nm / RX1310 nm)
  • 1000BASE-BX, at 40 km (TX1310 nm / 1550 nm)
  • 1000BASE-BX, at 40km (TX1550 LC nm / RX1310 nm)
  • 100Base-BX Fast Ethernet Optics, at 20 km (TX 1310 nm / RX 1550 nm)
  • 100Base-BX Fast Ethernet Optics, at 20 km (TX 1550 nm / RX 1310 nm)

Note: The 1-Port SFP Mini-PIM with Ethernet connector provides 1000-Mbps link speed. Actual bandwidth is limited to 100 Mbps.

Note: We strongly recommend the use of Juniper Networks SFP and XFP transceivers. We cannot guarantee correct operation if other transceivers are used. The transceiver type can be different in each port, as long as a supported part number is used.