T1600 Rear Cable Management System Description

Note: The rear cable management system is not needed for standalone T1600 routers with T1600-SIBs and T-CBs.

For T1600 routers connected to a TX Matrix Plus router, you can use the rear cable management system to organize, support, and provide strain relief for the fiber-optic array cables connected to the TXP-T1600 SIBs, and the cables connected to the LCC-CBs. The cables are routed to the left side of the T1600 router, and then toward the top of the chassis, where you can route the cables to the TX Matrix Plus router. The cable management system adds 9.5 in (24.1 cm) to the depth of the T1600 chassis, and 2.4 in (6.2 cm) to the left side of the chassis.

See the TX Matrix Plus Router Hardware Guide  for instructions on installing and using the T1600 rear cable management system.

The rear cable management system consists of one cable management arm as shown in Figure 1.

Figure 1: T1600 Rear Cable Management System