Description
|
- Four 10-Gigabit Ethernet ports
- Power requirements: 0.9 A @48 V (43 W)
|
Hardware features
|
- High-performance throughput
- WAN-PHY mode at 9.953 Gbps
- LAN-PHY mode at 10.3125 Gbps
- Full-duplex mode
- Large maximum transmission units (MTUs) of up to 9192
bytes
|
Software features
|
- Configurable WAN-PHY mode options:
- loopback
- mpls
- path-trace
- trigger
- Flexible Ethernet Services Encapsulation
- 802.1q virtual LANs (VLANs)
- Ethernet OAM 802.1ag continuity check
- Ethernet OAM 802.3ah (remote loopback is not supported
for this PIC)
- VLAN stacking
- Channels defined by two stacked VLAN tags
- Multiple tag protocol identifiers (TPID) support
- IP service for nonstandard TPID and stacked VLAN tags
- MAC learning, accounting, and filtering
- Virtual Router Redundancy Protocol (VRRP) support
|
Cables and connectors
|
- You can install any transceiver supported by the PIC.
For information about installing and removing transceivers, see the PIC and Transceiver Installation
Instructions.
- Fiber-optic 10-gigabit small form-factor pluggable (XFP)
transceivers:
- Connector: Duplex LC/PC (Rx and Tx)
- Optical interface support—See Table 28
|
LEDs
|
Port LED, one for each port:
- Off—Port is not enabled.
- Green—Port is online with no alarms or failures.
- Amber—Port is online with alarms for remote failures.
- Red—The router has detected a failure with alarms
for local failures.
|
