no log destination syslog ipAddress { include | exclude } [ category ]*
Release Information
Command introduced before JUNOSe Release
7.1.0.
Description
Configures the logging of system messages. You
can direct messages to a destination, limit the messages logged based
on severity level, or limit the event categories for which messages
are logged. The no versions restore default
settings or reverse the effect of previous commands that limited event
categories.
Note:
You can display traffic logs—such as ipTraffic,
icmpTraffic, tcpTraffic, and udpTraffic—only via the show log data command
or from the SRP module console. You cannot redirect
traffic logs elsewhere, such as to a system log or nonvolatile storage
file, or to a Telnet session.
Options
console—Configures or modifies logging to the local
console
nv-file—Configures or modifies logging to the nonvolatile
log file; the nv-file can accept only events at a severity level of
critical or higher in importance
syslog—Configures or modifies logging to a system
log server
ipAddress—IP address of the
system log application on a remote host
facility—Specifies the system log facility on the
host
facilityId—Number in the range
0–7 that identifies the corresponding logging facility, local0–local7
severity—Sets minimum severity of the log messages
displayed; described either by a descriptive term—severityValue—or by a corresponding number—severityNumber—in the range 0–7. The lower
the number, the higher the priority:
emergency or 0—System unusable
alert or 1—Immediate action
needed
critical or 2—Critical condition
exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant
condition
info or 6—Informational message
debug or 7—Debug message
off—Disables logging to this destination
include—Sends only the specified event categories
to the system log server
exclude—Sends all event categories except those
specified to the system log server
Issuing an includecommand after an excludecommand (or vice versa) overrides the earlier
command.
You can issue successive includecommands
or successive excludecommands. Successive
commands expand the list of included or excluded categories.
category—Log category; refer
to the CLI online Help for available options
*—Indicates that one or more parameters can be repeated
multiple times in a list in the command line
