VPLS is supported on all E-series routers.
You can configure VPLS network interfaces on all E-series module combinations that support transparent bridging. The VPLS virtual core interface can exist on all E-series module combinations that support MPLS tunnels.
For information about the modules that support VPLS network interfaces and VPLS virtual core interfaces on ERX-14xx models, ERX-7xx models, and ERX-310 routers:
For information about the modules that support VPLS network interfaces and VPLS virtual core interfaces on E120 routers and E320 routers:
The configuration task examples in this chapter use the slot/port[.subinterface ] format to specify the physical interface on which to configure a VPLS network interface. However, the interface specifier format that you use depends on the router that you are using.
For ERX-7xx models, ERX-14xx models, and ERX-310 routers, use the slot/port[.subinterface ] format. For example, the following command specifies Fast Ethernet subinterface 6 on port 2 of the I/O module installed in slot 3 of an ERX-7xx model, ERX-14xx model, or ERX-310 router.
For E120 and E320 routers, use the slot/adapter/port[.subinterface ] format, which includes an identifier for the bay in which the I/O adapter (IOA) resides. In the software, the upper IOA bay is identified as adapter 0; the lower IOA bay is identified as adapter 1. For example, the following command specifies Gigabit Ethernet subinterface 20 on port 1 of the IOA installed in the upper adapter bay (adapter 0) of slot 4 in an E320 router.