Specifies the duplex mode for an Ethernet interface.
This command works with the speed command;
if you set or accept the automatically negotiate setting for either
duplex mode or speed, the router negotiates both parameters with the
remote device. The no version specifies
the default value, automatically negotiate or full duplex (FE-8 SFP
I/O module only). This command is not available for the Ethernet interface
on the SRP module.
Options
duplexMode—One of the following
duplex options
automatically negotiate—Specifies that the router
negotiates duplex mode with the remote device; not valid for the FE-8
SFP I/O module
full—Specifies that the router uses full duplex
on a Fast Ethernet or Gigabit Ethernet interface
half—Specifies that the router uses half duplex
on a Fast Ethernet interface; this value is not valid for Gigabit
Ethernet interfaces
