The L2TP network server (LNS) sends RADIUS authentication requests or accounting requests. Authentication requests are sent out to the authentication server port. Accounting requests are sent to the accounting port. To configure RADIUS authentication for L2TP on an M10i or M7i router, include the following statements at the [edit access] hierarchy level:
Note: The RADIUS servers at the [edit access] hierarchy level are not used by the network access server process (NASD).
You can specify an accounting port number on which to contact the accounting server (in the accounting-port statement). Most RADIUS servers use port number 1813 (as specified in RFC 2866, Radius Accounting).
Note: If you enable RADIUS accounting at the [edit access profile profile-name accounting-order] hierarchy level, accounting is triggered on the default port of 1813 even if you do not specify a value for the accounting-port statement.
server-address specifies the address of the RADIUS authentication server (in the radius-server statement).
You can specify a port number on which to contact the RADIUS authentication server (in the port statement). Most RADIUS servers use port number 1812 (as specified in RFC 2865, Remote Authentication Dial In User Service [RADIUS] ).
You must specify a password in the secret statement. If a password includes spaces, enclose the password in quotation marks. The secret used by the local router must match that used by the RADIUS authentication server.
Optionally, you can specify the amount of time that the local router waits to receive a response from a RADIUS server (in the timeout statement) and the number of times that the router attempts to contact a RADIUS authentication server (in the retry statement). By default, the router waits 3 seconds. You can configure this to be a value in the range from 1 through 90 seconds. By default, the router retries connecting to the server three times. You can configure this to be a value in the range from 1 through 10 times.
In the source-address statement, specify a source address for each configured RADIUS server. Each RADIUS request sent to a RADIUS server uses the specified source address. The source address is a valid IPv4 address configured on one of the router interfaces.
To configure multiple RADIUS servers, include multiple radius-server statements. For information about how to configure the RADIUS disconnect server for L2TP, see Configuring the RADIUS Disconnect Server for L2TP.
Note: When the L2TP network server (LNS) is configured with RADIUS authentication, the default behavior is to accept the preferred RADIUS-assigned IP address. Previously, the default behavior was to accept and install the nonzero peer IP address received by the Internet Protocol Control Protocol (IPCP) configuration request packet.