Understanding Node Devices

Node Device Introduction

A Node device in the QFabric switch connects either endpoint systems (such as application servers and storage devices) or external networks to Interconnect devices. It can be used similarly to the way a top-of-rack switch is implemented in a data center. Node devices provide an access point to the QFabric switch system, allowing data to flow into and out of the QFabric switch. Because all Node devices in the QFabric switch connect through a backplane of Interconnect devices, in essence all Node devices are connected to one another. This directly connected design model eliminates multiple tiers of aggregation and core devices and provides minimum latency, maximum scalability, and rapid transport of server-to-server traffic and QFabric switch-to-external network traffic.

Sets of Node devices can be bundled together into Node groups, in which each group operates as a single virtual entity. Node groups that connect to servers and storage devices are known as server Node groups, and Node groups that connect to external networks are known as network Node groups.

QFX3500 Node Devices

The QFX3500 Node device works as part of a QFX3000 QFabric switch. A QFX3500 chassis provides up to 48 10-Gigabit Ethernet interfaces to connect to endpoints or external networks. You can configure 12 of these 48 interfaces to support 2-Gbps, 4-Gbps, or 8-Gbps Fibre Channel. You can also configure the remaining 36 interfaces with Gigabit Ethernet.

Note: You can configure interface ports 0 through 47 as 10-Gigabit Ethernet ports, 0 through 5 and 42 through 47 as Fibre Channel over Ethernet ports, and 6 through 41 as Gigabit Ethernet ports. However, you cannot configure any Fibre Channel over Ethernet ports as Gigabit Ethernet ports or vice versa.

In addition to these server and network interfaces, there are four uplink interfaces to connect the QFX3500 Node device to Interconnect devices in a QFabric switch. These uplinks use 40-Gbps quad small form-factor pluggable plus (QSFP+) interfaces.

The control plane requires two management ports on the QFX3500 chassis to connect the Node device to the control plane network. Figure 1 shows an example of the data plane and control plane connections for a QFX3500 Node device.

Figure 1: QFX3500 Data Plane and Control Plane Connections