Technical Documentation
ntp
Syntax
ntp -T system:mm[x] <-en (enabled | disabled)> <-i ip-address | hostname> <-f update-frequency> <-synch>
Release Information
Command supported by Junos OS Release 9.1 and later.
Description
(JCS management module CLI) Configure or display the JCS management module network time protocol (NTP) settings.
Options
-T system:mm[x]—Specify a JCS management module as the command target. Replace x with the primary management module number (1 or 2). The JCS management module is the only valid target available for this command.
-en (enabled | disabled)—(Optional) Enable or disable NTP for the JCS management module.
-i ip-address|hostname—(Optional) IP address or hostname of the NTP server.
-f update-frequency—(Optional) Update frequency (in minutes). The JCS management module clock is automatically updated at the frequency specified. Replace update-frequency with a value from 1 through 45000.
-synch—(Optional) Synchronize the JCS management module clock with the NTP server.
Required Privilege Level
operator (display)
supervisor (display or configure)
List of Sample Output
ntp (Display)ntp (Configure)
Output Fields
Table 1 lists the output fields for the ntp command. Output fields are listed in the approximate order in which they appear.
Table 1: ntp Output Fields
Field Name | Field Description |
|---|---|
-en | NTP status (enabled or disabled). |
-i | IP address or hostname of the NTP server. |
-f | How often (in minutes) the JCS management module is updated by the NTP server. |
-v3en | V3 authentication status (enabled or disabled) between the JCS management module and the NTP server. |
Sample Output
ntp (Display)
system> ntp -T system:mm[1]-en enabled -i timeserver -f 5 -v3en disabled
ntp (Configure)
system> ntp -T system:mm[1] -en enable -I timeserver2
-f 15OK
