ifconfig (JCS Management Module)

Syntax

ifconfig -T system:mm[x] (-eth0 | -eth1) <enabled | disabled> <-c static> <-g gateway-address> <-i static-ip-address> <-s subnet-mask>

Release Information

Command supported by Junos OS Release 9.1 and later.

Description

(JCS management module CLI) Configure or display the JCS management module Ethernet interface.

Options

-T system:mm[x]—Specify a JCS management module as the command target. Replace x with the primary management module number (1 or 2). The JCS management module is the only valid target available for this command.

-eth0 | -eth1—Specify Ethernet channel 0 or Ethernet channel 1.

enabled | disabled—(Optional) Enable or disable the Ethernet interface on the JCS management module.

-c static—(Optional) Specify static IP configuration.

-g gateway-address—(Optional) Gateway IP address of the Ethernet interface on the JCS management module.

-i static-ip-address—(Optional) Static IP address of the Ethernet interface on the JCS management module.

-s subnet-mask—(Optional) Subnet mask of the Ethernet interface on the JCS management module.

Required Privilege Level

operator (display)

supervisor (display or configure)

List of Sample Output

Output Fields

Table 1 lists the output fields for the ifconfig command. Output fields are listed in the approximate order in which they appear.

Sample Output

Enabled
-i 192.168.171.96 
-g 192.168.171.254
—s 255.255.252.0
-c static

OK