Elevate

Welcome to the Juniper Elevate Community

hero image

Promoted

Promo tile background

Check out the new TechPost 

Bits and Bytes Articles on Automated WAN Solutions, from Network Engineers to Network Engineers.

Browse Posts

Latest Discussions

  • Posted in: SRX

    I will certainly do what has been recommended. I realize I need to make some changes to my equipment. I use it as an intermediate device. It has use, and safety is a concern. Thx, Puluka ------------------------------ Adrian Aguinaga B.S.C.M. I.T.T. Tech (Construction Management) A.A.S. I.T.T. Tech ...

  • Posted in: SRX

    Hello, my SRX300 says that it boots from the backup partition: *********************************************************************** ** ** ** WARNING: THIS DEVICE HAS BOOTED FROM THE BACKUP JUNOS IMAGE ** ** ** ** It is possible that the primary copy of JUNOS failed to boot up ** ** ...

  • Posted in: SRX

    Hello everyone, I'm currently working on monitoring the traffic exchanged with one of our clients using either SRX1500 or SRX550, both running software version 19.4. We're utilizing a VPLS connection for this communication. I'd like to implement a port mirroring solution to analyze this traffic in-depth. ...

  • Posted in: Routing

    Hi, I would suggest to try 2 things Try to use IP address instead of interface as next-hop in COS forwarding policy. In policy statement itself, I think accept action is unnecessary for T1 term, just COS next-hop-map should be enough. ------------------------------ FARID AKHUNDOV ----- ...

  • Posted in: Routing

    In case next hop of the received prefix from eBGP neighbor is not reachable, it will not be accepted. Even if you apply import policy to fix the next hop, the prefix needs to first be ACCEPTED, after which its next can be modified. Classic example is 6PE, when you use a single IPv4 link for both IPv4 ...

  • Posted in: Routing

    Hi Marc, I know it is old thread but it contains a lot of valuable info. By default, Junos OS does not maintain the route for indirect next hop to forwarding next-hop binding on the Packet Forwarding Engine forwarding table... .so that is why special configuration is needed to accept those indirect ...

  • Posted in: SRX

    Will two SRX directly connected be permanent or is this a staged replacement plan? For the two interfaces connected I see that the SRX300 is in trunk mode with two vlans assigned and the SRX550 is in access mode with 1 vlan (all that can be assigned). If you need to bridge two vlans than both ports ...

Latest Articles

  • Blog Entry
    Posted to: TechPost Blogs

    High-level functionality description of BIER as MVPN provider tunnels in the upcoming release of PTX Express 5. Introduction In Cheers! Have a BIER , we explained how BIER [RFC8279] works and how it has come to a prime time for BIER deployment with the hardware capabilities from several major vendors across the edge/access/core platforms. ...

  • Blog Entry
    Posted to: TechPost Blogs

    What does differentiate the ACX7024X from the ACX7024 devices? In this short article, we will explain the differences and the motivation behind the creation of this new router. Introduction We launched the ACX7024 in mid-2022, with the following characteristics: 1RU Ethernet router. Built for the aggregation of SFP ...

  • Blog Entry
    Posted to: TechPost Blogs

    Using Juniper vSRX on hardware with constrained resources, typically a mini-PC serving as flexible Internet gateway. Those are lately very popular due to low footprint yet with capabilities making them suitable for running virtual machines. Introduction At very minimum, a mini-PC is tool for engineers to have x86 based SRX ( vSRX ) at home ...

Top Contributors of the Week